Additional Security . . .
Torx security screws are available (as optional equipment at extra cost) for securing both lower access panels to each dryer base. Order part number 62853.
A Torx bit, part number 282P4, is available (as optional equipment at extra cost) for installing the Torx security screws.
A Torx bit holder, part number 24161, is available (as optional equipment at extra cost) to be used with the Torx bit.
Slide Extension . . .
(Metered Models)
Remove two slide extensions, four screws and lockwashers from the accesssories bag (located in lower cylinder) and install the extension on the top of the coin slide.
IMPORTANT: Slide extension must be attached to top side of the coin slides to make them long enough to activate the accumulator.
NOTE: This dryer unit, as shipped from the factory, does not include the coin slides, coin drawers, lock or keys. These coin slide kits (or parts) must be ordered, at extra cost, according to the purchaser’s requirements direct from the coin kit manufacturer of your choice.
Timer Cams . . .
(Metered Models)
The dryer timers are factory equipped with a 45 minute timing cam. If this drying time is not suitable to your installation, the following cams can be found in the accessories bag (located in lower cylinder).
ELECTRIC DRYERS
GAS DRYERS
A 60 minute timing cam, Part No. 53240, is available for the gas dryers as optional equipment at extra cost.
Lower Front Panel Security . . .
(Optional)
(Metered Models)
For added security, remove the two screws (with lockwashers) from accessories bag (located in lower cylinder). Install screws as follows:
1.Unlock control panel.
2.Lift up on control panel and swing bottom of panel out, then pull down and away from control cabinet.
3.Install the two screws down through holes in lower flange of control cabinet and into top flange of lower front panel.
504524 | 7 |