Alliance Laundry Systems F232139R3 Cycle Charts, NOTE: Compartment 2 does not flush when supply 4 is called for in a program

Programming

3.Use Up or Down (arrow) key to select fill temperature: cold (CFIL), hot (HFIL) or warm (bFIL). Press Start (#) key.

4.Use Up or Down (arrow) key to select fill level: low level (LOLE) or high level (HILE). Press Start (#) key.

5.Use Up or Down (arrow) key to select supply option. Refer to Table 3. Press Start (#) key.

	Supply Options

Display		Supply

SUP0		No Supply

SUP1		Supply 1

SUP2		Supply 2

SUP3		Supply 3

SUP4		Supply 4

SUP5		Supply 1 and 2

SUP6		Supply 2 and 3

SUP7		Supply 3 and 4

	Table 3

The Supply Dispenser Compartment functions as follows: Supply compartment 1 flushes with each fill. Supply compartment 2 flushes when the program calls for supply 2 during a fill. Supply compartment 3 flushes when the program calls for supply 3 during a fill.

The Chemical Injection Supply Nozzles located in their respective supply compartments function as follows: Chemical supply nozzle 1 empties into compartment 1, chemical supply nozzle 2 and 4 empty into compartment 2, and chemical supply nozzle 3 empties into compartment 3. Refer to Figure 2.

Supply Dispenser

Compartments

1 2 3

1 2 4 3

Chemical Injection

Supply Nozzles

B009RE3A

Supply Dispenser Compartments

1Detergent

2Bleach

3Softner

Chemical Injection Supply Nozzles

1Detergent

2/4 Bleach

3Softner

Figure 2

NOTE: Compartment 2 does not flush when supply 4 is called for in a program.

6.If machine is equipped with auxiliary heating system, use Up or Down (arrow) key to select desired segment temperature. Set value to zero to disable auxiliary heat for this segment. Press Start (#) key.

NOTE: Do not program heat steps for machines not equipped with auxiliary heat. The machine will pause for 30 minutes during any step in which the fill water temperature does not already equal or exceed the programmed value of the heat step.

7.Use Up or Down (arrow) key to select spin time. Set value to zero to skip spin step. Press Start (#) key. Display will now show the identifier for next program segment.

8.Press the Stop (#) key to complete cycle programming procedure.

Refer to the Cycle Charts section for detailed description of cycles.

F232139