Supply Options

Display

Supply

 

 

SUP0

No Supply

 

 

SUP1

Supply 1

 

 

SUP2

Supply 2

 

 

SUP3

Supply 3

 

 

SUP5

Supply 1 and 2

 

 

SUP6

Supply 2 and 3

 

 

8.Press the Start key.

9.Use the Up or Down key to select the desired spin time. Set this value to zero to skip the spin step.

10.Press the Start key. The display will show the identifier for next program segment or cycle option. If the edited segment is the final (Fill 6) segment in the cycle, the display will show the cycle number.

Note: Every intermediate spin is followed by a 25-second coast-down period, which occurs during the fill step for the following segment.

11.Press the Stop key at any time to complete the cycle programming procedure.

Test Cycle

When program mode is first entered, the display shows temperature. To enable the factory test cycle, press the Down key. The display will read “tESt.”

Programming

To run the test cycle, proceed as follows:

1.Enter RUN mode by moving the PROGRAM/RUN mode toggle switch back to the down position.

2.Verify that the RUN/PROGRAM mode toggle switch is in the RUN position.

3.To run the test cycle, enter the required number of coins and press the Start key.

The test cycle is as follows:

a.Once the Start key is pressed, the door interlock engages, the drain valve closes, the cylinder begins agitating at wash speed, and both water inlet valves are energized. The display alternately flashes “bFIL” and “LO” (both hot and cold fill valves on, filling to low level).

b.The display continues flashing “bFIL” and “LO” (both hot and cold fill valves on–fill to low water level), motor agitates forward and reverse, and drain is closed. Fill valves go off when low water level is reached and dot above rightmost digit lights.

c.When low water level is reached, the

display flashes “CFIL” and “ ned” (cold fill valve on–fill to medium water level), basket rotates counterclockwise and clockwise, and the drain is closed. Fill valve goes off after medium water level is reached and dot above third digit from left lights.

d.When medium water level is reached, the display flashes “HFIL” and “HI” (hot fill valve on–fill to high water level), the basket rotates counterclockwise and clockwise, and the drain is closed.

25

F232061