Alliance Laundry Systems LTS84B*H Timer, DOOR LOCKED Light, Out of Balance Load, End of Cycle Signal, Before Washing

Operating Instructions

Timer

Although the washer cycles are automatic, the timer may be reset to lengthen, shorten or repeat a portion of a cycle.

To set or reset the timer, push timer knob in to stop the washer. Hold timer knob in firmly while slowly turning it clockwise to the setting desired. Pull timer knob out to start the washer.

DOOR LOCKED Light

When the washer is started, the DOOR LOCKED light will come on after a short delay. The light will turn off 10 to 30 seconds after the cycle is complete.

Out of Balance Load

If at the end of the cycle, the load is dripping wet, the washer has limited the spin speed. This is to prevent damage to the unit if there is a severely unbalanced load.

If this condition occurs, redistribute the load manually and repeat the cycle beginning at the last rinse.

If the condition persists, consider steps discussed in the Before Washing section of the Use and Care Guide.

End of Cycle Signal

W549I

The volume of the signal tone may be set on OFF, LOUD or between the two selections. If a volume level is selected, the signal tone will buzz on and off when the cycle is completed. The signal will stop when the door is opened, or when the timer has advanced to an OFF position.

NOTE: If the signal comes on and remains on, the washer may have sensed an error. Unplug the washer, shut water off to washer and contact a service person.

4 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 800975