Alliance Laundry Systems LTS95A*N To Change Cycles, To Wash Clothes, To change the cycle after the first wash is complete:, To change the cycle before the first fill is complete:

7.Select the cycle according to the type of fabric being washed. Use the indicator dot on the knob as a guide.

	OFF			CYCLE SELECTION
	OFF
SPIN ONLY	801	3	8 9 W	REGULAR
RINSE & SPIN				PERMANENT PRESS
	DELICATE

FLW1996N

8.Press and hold the START button for two seconds to start the washer. The DOOR light will come on after a short delay, water fill will begin, and wash drum will begin tumbling.

NOTE: Washer door MUST be closed tightly to start washer.

If items need to be added or removed after a cycle has started, turn the Cycle Selector knob to the OFF position. Wait until the DOOR light goes off (approximately 45 seconds after cycle has been stopped), open door, add or remove items, and start the cycle again.

There is no agitator on this washer. Instead, the clothing gently tumbles through the water. The wash action consists of a period of tumbling in one direction, a brief pause, and then a reverse tumble in the opposite direction. The pauses are part of the tumble action and add to the uniqueness of the washer. They are part of the cycle.

NOTE: There will be extended pauses when Boosted Hot Wash is selected because the water is being heated.

To Change Cycles

If the selected cycle is not the correct cycle for the fabric being washed, you may change the cycle selection at any time until the first wash fill is complete. Once the washer has filled for the first part of the cycle (the wash portion), the current cycle must be aborted and a new cycle must be started.

To change the cycle before the first fill is complete:

Change the cycle selected on the cycle selector knob.

To change the cycle after the first fill is complete and before the first wash is complete:

1.Abort the current cycle by changing the cycle selector knob to the OFF position.

2.Set the WASH/RINSE temperature selector.

3.Set cycle selector.

4.Turn on extra rinse, if desired.

5.Press and hold the START button for two seconds.

To change the cycle after the first wash is complete:

NOTE: This should only be done if the speed of the final extract is incorrect for the fabric being washed. For example, if washing delicate items on the REGULAR cycle, the high speed extract may damage the fabric. If washing towels or jeans on the DELICATE cycle, the lower speed extract would increase drying time.

1.Abort the current cycle by changing the cycle selector knob to the OFF position.

2.Restart the cycle from the beginning. Refer to the To Wash Clothes section.

801405