Additional Security
Torx security screws are available (as optional equipment at extra cost) for securing lower access panel to dryer base. Order part number 62853.
A Torx bit, part number 282P4, is available (as optional equipment at extra cost) for installing the Torx security screws.
A Torx bit holder, part number 24161, is available (as optional equipment at extra cost) to be used with the Torx bit.
Slide Extension
(Coin Slide Models Only)
Remove slide extension, screws and lockwashers from the accessories bag and install the extension on the top of the coin slide.
IMPORTANT: Slide extension must be attached to top side of the coin slide to make it long enough to activate the accumulator.
NOTE: This dryer, as shipped from the factory, does not include the coin slide, coin drawer, lock or keys. This coin slide kit (or parts) must be ordered, at extra cost, according to the purchaser’s requirements direct from the coin kit manufacturer of your choice.
Timer Cams
(Coin Slide Models Only)
The dryer timers are factory equipped with a 45 minute timing cam. If this drying time is not suitable to your installation, the following cams can be found in the accessories bag.
ELECTRIC DRYERS
GAS DRYERS
A 60 minute timing cam, Part No. 53240, is available for the gas dryer as optional equipment at extra cost.
To change the timing cam:
1.Align notch in cam with a tooth on ratchet wheel.
2.Squeeze the ends of the two timing cam prongs together.
3.Carefully lift timing cam off post.
Installation
NOTE: Adjust ratchet wheel and timing cam to “OFF” position prior to putting dryer into use. Refer to Figure 1 for proper position.
1
6 
5 
42
3
D775I
7
D775I
1Retaining Prongs
2Timing Cam
3Notch
4Levers
5Off Position
6Ratchet Wheel
7On Position
Figure 1
510977 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 7 |