Setup Mode (For Earlier Models)

NOTE: In Setup Mode, certain machine functions can be configured. The settings in this mode are related to how the machine is equipped from the factory. Usually, these would not be changed in this field.

NOTE: Enter Setup Mode through the Program Mode.

1. Press (*) key. Display will show “FAr” or “CEL”.

NOTE: This selects whether temperatures display in degrees Fahrenheit (F) or Celsius (C), if control is equipped with a temperature sensor. Press the (∧) or (∨) key to change.

NOTE: Changing degrees “FAr” or “CEL” only has an effect if the control has a temperature probe connected and/or heat capability.

2.Press START key.

3.Model will display “HEAt” or “noHt”. Change the selection by pressing the (∧) or (∨) key.

4.Press START key to continue to the next step.

NOTE: If set for “HEAt”, the control has heat capability enabled. The washer-extractor MUST have electric or steam heat, and a temperature probe. If display shows “noHt”, or if the message “HEAt” or “noHt” does NOT display, the control does NOT have heat capability.

5.Certain models will display “EFIL” or “ESUP”. For these models, the control provides a spare output (for certain models). The spare output can be set up to control an extra fill valve (“EFIL”), with the ability to fill to a programmable water level (just as for regular fills), OR the spare output can be set up to control an extra chemical supply signal (“ESUP”).

6.Press START keypad.

7.Certain models display “bEEP” (control sounds beeper during Add Bleach [Supply 2]) or “nobP” (control does NOT sound beeper during Add

Bleach [Supply 2]). Change selection by pressing (∧) or (∨) keypad.

8.Press START keypad.

Programming

NOTE: If “EFIL” or “ESUP” does NOT display, the extra fill capability is NOT present. If either message does display, change the selection by pressing the (∧) or (∨) key. Press START key to return to Program Mode. Refer to “Programming Cycle Segments” section for additional information.

Cycle and Error Count

The control logs cycle count (total of all cycles completed).

●To read, enter Program Mode.

●Press START (enter) key. Display will show the cycle count.

●Press START (enter) key. Display will show certain error conditions that may have been recorded by the control.

●Read the information when consulting technical assistance as needed.

●Step through the error log by pressing START key repeatedly until display reverts to normal Program Mode (showing a temperature).

F232168

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

7