Alliance Laundry Systems UW35B2, UW60B2 13

	Programming
Table 1 (Continued)

Cycle Steps Available	Setting Options for Cycle Steps
(NOTE: WASH, ADD BLEACH, RINSE, and SPIN	(Press START key to advance to next row selection,
LEDs light ONLY when a cycle formula is in	(∧) to increase a value or change, (∨) to decrease a
operation.)	value or change, or (∗) to save and exit.)


Rinse 1 (displayed as “rIn1”), lights RINSE LED (during operation)

Time for agitation (excludes fill, drain, spin, heat)	0 or 2-15 minutes (one-minute increments)

Fill valves (temperature)	Cold, Hot, Warm (Cold & Hot) or “EFIL”†††

Fill water level	Low, Medium, or High

Supply	None (0), 1, 2 (liquid bleach††††), 3, 4, 5†††††, 6 (1 and 2
	together displays as “SUP6”), or 7††††† (Supply 4 and extra
	supply 5 together displays as “SUP7”).

Heat (appears ONLY for models with heat capability)	00F (no heat for segment), or 80°F to 205°F
	00C (no heat for segment), or 27°C to 95°C

Drain (Select Drain or No Drain. Final segment drains in	Drain or No Drain (if No Drain, skips the spin step which
stop routine if No Drain is programmed.)	automatically sets that spin time = 0)

Spin time	0 or 30-240 seconds (one-second increments)


Rinse 2 (displayed as “rIn2”), lights RINSE LED (during operation)

Time for agitation (excludes fill, drain, spin, heat)	0 or 2-15 minutes (one-minute increments)

Fill valves (temperature)	Cold, Hot, Warm (Cold & Hot) or “EFIL”†††

Fill water level	Low, Medium, or High

Supply	None (0), 1, 2 (liquid bleach††††), 3, 4, 5†††††, 6 (1 and 2
	together displays as “SUP6”), or 7††††† (Supply 4 and extra
	supply 5††††† together displays as “SUP7”).

Heat (appears ONLY for models with heat capability)	00F (no heat for segment), or 80°F to 205°F
	00C (no heat for segment), or 27°C to 95°C

Drain (Select Drain or No Drain. Final segment drains in	Drain or No Drain (if No Drain, skips the spin step which
stop routine if No Drain is programmed.)	automatically sets that spin time = 0)

Spin time	0 or 30-240 seconds (one-second increments)

Table 1 (Continued)

†Normal Agitation is 12 seconds forward, 3 seconds off, 12 seconds reverse, 3 seconds off, and repeat.

††Gentle Agitation is 3 seconds forward, 12 seconds off, 3 seconds reverse, 12 seconds off, and repeat.

†††Extra Fill (“EFIL”) possible only if configured for “EFIL” in Setup Mode.

††††ADD BLEACH LED lights if Supply 2 is the only supply programmed and if set up for “bEEP” (refer to Setup Mode section). ADD BLEACH LED and Supply 2 signal are on for up to 45 seconds, or until the programmed water level is reached, whichever occurs first. If “bEEP” is enabled, beeper begins beeping when Supply 2 comes on and beeps for 8 seconds.

†††††Appears only if “ESUP” (extra supply) configured in Setup Mode.

F232168