Rapid Advance (For Models With Firmware ID Code “o2HC”, “o2UC”, “ouHC” and “ouUC”)
NOTE: Rapid Advance (“Adv”) possible only if configured for “Adv” in Setup mode. Refer to Setup Mode.
How to Rapid Advance During All Steps (Except First Fill Step)
1.Make sure Rapid Advance is enabled.
2.Press the advance (∧) keypad to advance to desired step.
3.Display will show recalculated time remaining.
How to Rapid Advance (During First Fill Step)
1.Make sure Rapid Advance is enabled.
2.While machine is filling with water, to advance to the next step, press START (enter) keypad to turn off the ability to change cycles.
3.Press the advance (∧) keypad to advance to desired step.
4.Display will show recalculated time remaining.
NOTE: If control is set up for ‘EtiM’, the remaining cycle time after using Rapid Advance step is calculated as if control was configured for ‘PtiM’. This is because any time estimations following advance would be inaccurate. After the cycle ends, and the advance mode is disabled, the next cycle display remaining cycle time based on the ‘EtiM’ configuration.
Agitation Step
Advance the cycle by pressing (∧) keypad to skip to the drain step. Filling, supply flushing and other signals turn off. Cycle remaining time is recalculated as the total remaining time after the agitation.
Drain Step
Advance the cycle by pressing (∧) keypad to skip the drain step and the following spin step. The spin step is skipped because the drain step needs to be completed to balance the load. The next step after the spin begins. Cycle remaining is recalculated as the total remaining time after the drain and spin steps.
Programming
Spin Step
Advance the cycle by pressing (∧) keypad to skip the spin step. The next programmed step after the spin begins. Cycle remaining is recalculated as the total remaining time after the spin step.
Test Cycle
The test cycle provides a convenient means of troubleshooting and testing all machine functions quickly.
●Enter Program Mode.
●Press the (∨) key. Display shows “tESt”.
●Return the Program/Run switch to the right.
●Press START key. The door locks and the test mode starts.
●Display shows “SPC?”. This is a factory test procedure. Ignore it and the machine will advance into the test cycle after about
five seconds.
F232168 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 17 |