The washer-extractor has 5 supply compartments, designated as compartments 1, 2, 3, 4 and 5. Compartment 1 is farthest to the rear of machine. Moving toward the front of machine, compartments are ordered 2, 3, 4 and 5 (at the front of machine). Supply signals 1 through 5 correspond to compartments 1 through 5. Supply signals 1, 2, and 3 have dedicated water valves that flush compartments 1, 2 and 3 (along with the signal being available for external supplies). Supply signal 4 operates a valve that flushes compartment 4. The supply signal is available for external supply connection. This valve is connected so that it also flushes supply compartment 5 when the supply 4 signal is on. For example, if supply 4 signal is programmed, it will flush compartments 4 and 5. Supply 5 is available to operate an external supply.

NOTE: For additional assistance, refer to installation instructions.

Heated Models Only

Display shows temperature in degrees F or C. Display will show degrees F if configured for “FAr” in Setup Mode, or degrees C if configured for “CEL” in Setup Mode. Range is 80°F to 205°F, or 00F (no heat for segment), or 27°C to 95°C, or 00C (no heat for segment).

Press the (∧) key to increase, or (∨) key to decrease temperature. Temperature changes in one-degree increments. The control will energize heat and pause cycle timing for up to 50 minutes until the programmed temperature is first reached.

NOTE: If temperature not reached after 50 minutes, control resumes cycle.

After cycle resumes, control will attempt to maintain programmed temperature if it senses water in the machine.

NOTE: Temperature display applies ONLY if machine is configured for “HEAt” in Setup Mode. Machine must be equipped with electric or steam heat and a temperature sensor. If configured for “noHt” (no heat capability) in Setup Mode, temperature display does not appear in the segment. After temperature setting, control will skip to “drAI”/“nodr” or Spin Time, depending on version.

Programming

If display shows “drAI”/“nodr” during segment programming, a drain step option can be selected. Select “drAI” for a drain step followed by an optional spin. Select “nodr” for no drain step. The machine will proceed directly to the next segment if “nodr”. Change the selection by pressing the (∧) or (∨) key. Press START to continue.

If “drAI” is selected (or if your model does not provide the option of selecting “drAI”/“nodr”), the display will show “SPIn” one second, “tInE” one second, and then the time for spin: “00” (no spin) for 30-240 seconds IF you are in Rinse 1, 2, or 3. If you are in Rinse 4, the time for spin will show 0 or 1-10 minutes. Change the selection by pressing the (∧) or (∨) key. Press START to continue. Then enter the next segment (rIN2, rIN3, rIN4 or exit if rIN4 is complete).

IMPORTANT: The spin time in Rinse 4 is programmed in minutes (0-10 minutes, in one-minute increments), while other spins are in seconds to allow for shorter times (such as

45 seconds). (Rinse 4 segment should usually be used as the final rinse, even where there may be fewer than four rinses. Program zero time for preceding rinses you wish to exclude.)

Display shows a temperature. Exit Program Mode by moving the Program/Run switch back to the left as seen from the front of the machine.

NOTE: The SPIN indicator LED will automatically light during the wash cycle when the last spin programmed in a cycle is operating (regardless of which segment).

F232168

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

15