Maintenance

End of Day

1.Clean the AC drive box filters:

a.Snap off the external plastic cover which contains the filter.

b.Remove the foam filter from the cover.

c.Wash the filter with warm water and allow to air dry. Filter can be vacuumed clean.

2.Clean the door gasket of residual detergent and all foreign matter.

3.Clean automatic supply dispenser and lid inside and out with mild detergent. Rinse with clean water.

4.Clean powder dispenser and lid with mild detergent. Rinse with clean water.

5.Clean washer-extractor’s top, front, and side panels with mild detergent. Rinse with clean water.

6.Leave loading door open at the end of each day to allow moisture to evaporate.

NOTE: Unload the washer-extractor promptly after each completed cycle to prevent moisture buildup. Leave loading door open at the end of each completed cycle to allow moisture to evaporate.

Weekly

1.Check the washer-extractor for leaks.

a.Start an unloaded cycle to fill the washer- extractor.

b.Verify that door and door gasket do not leak.

c.Verify that the drain valve is operating and that the drain system is free from obstruction. If water does not leak out during the prewash segment, drain valve is closed and functioning properly.

Monthly

NOTE: Disconnect power to the washer-extractor at its source before performing the monthly maintenance procedures.

1.Each month OR after every 200 hours of operation, lubricate bearings. (Locate the bearing lubrication decal at the rear of the left side of the control module, as viewed from the front of the washer-extractor.)

The grease must have the following characteristics:

NLGI Grade 2

Lithium-based

Water-insoluble

Anti-rusting

Anti-oxidizing

Mechanically stable

18

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232183