Allied Air Enterprises 95G1UH, A95UH, A93UH, 92G1UH Typical Air Intake Pipe Connections

1.Use transition solvent cement or a sheet metal screw to secure the intake pipe to the inlet air connector.

2.Route piping to outside of structure. Continue with installation following instructions given in general guide lines for piping terminations and in intake and exhaust piping terminations for direct vent sections. Refer to Table 5 for pipe sizes.

TYPICAL AIR INTAKE PIPE CONNECTIONS

UPFLOW NON-DIRECT

VENT APPLICATIONS

NOTE: Debris screen and elbow may be rotated, so that screen may be positioned to face forward or to either side.

Figure 26

TYPICAL AIR INTAKE PIPE CONNECTIONS

HORIZONTAL NON-DIRECT VENT APPLICATIONS

(Horizontal Right-Hand Air Discharge Application Shown)

NOTE: Debris screen may be positioned straight out (preferred) or with an elbow rotated to face down.

Figure 27

506501-01 Issue 1031 Page 21 of 48