Quick Install Guide | 5 |
5.Apply power to the router.
Fit the power cord retaining clip to the AC power inlet on the router’s rear panel.
Connect the provided power cord to the AC power inlet and clip it in place. Switch the router’s power switch to the ON position. The Power LED will light continuously and the System LED will flash briefly. The Port LEDs may also light briefly.
If the LEDs fail to light, the most likely cause is that the router is not receiving power. Check that
•The power supply outlet’s switch (if any), and the router’s power switch, are in the ON position
•The power cable is securely plugged in
•The power supply is operational
If the LEDs light incorrectly, refer to the AR Router Hardware Reference for troubleshooting information.
Figure 1: Front and rear panels of an AR450S, showing the AC power inlet, power switch, console ports and Ethernet ports, and their associated LEDs.
Configuring the Router
AR450S routers can be configured via the Command Line Interface (CLI) or
Graphical User Interface (GUI).
Using the CLI to configure a router:
1.Initiate router
Using the terminal cable supplied, connect a
