Nortel Networks Essential Nortel Commands: Key Routing and VLAN Configurations

IP routing configuration using the CLI 59

The syntax for the show vlan ip command is:

show vlan ip [vid <1 - 4094>]

Substitute <1 - 4094> above with the VLAN ID of the VLAN to be displayed.

Static route commands

This section discusses the commands used to display and configure static routes on the Nortel Ethernet Routing Switch 5500 Series.

show ip route static command

The show ip route static command displays all static routes, whether these routes are active or inactive.

The syntax for the show ip route static command is:

show ip route static [<A.B.C.D>] [-s <O.P.Q.R> <W.X.Y.Z>]

The following table outlines the parameters for this command.

ip route static parameters

Parameters	Description
< A.B.C.D>	Enter IP address to display the static route for the
	specific IP address.
-s <O.P.Q.R>	Enter IP address for the subnet to display.
< W.X.Y.Z>	Enter subnet mask address for the subnet to display.

The show ip route static command is executed in the User EXEC command mode.

show ip route command

The show ip route command displays all active routes in the routing table.

Route entries appear in ascending order of the destination IP addresses. The syntax for the show ip route command is:

show ip route [<A.B.C.D.W.X.Y.Z.> <summary>]

show ip route command output

			Ip Route
DST	MASK	NEXT	COST	VLAN	PORT	PROT	TYPE	PRF
0.0.0.0	0.0.0.0	10.3.2.137	1	1	1/21	S	IB	5
2.2.2.0	255.255.255.0	2.2.2.2	1	2	----	C	DB	0

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks