IP routing configuration using the CLI 79

default ip rip cost command

The default ip rip cost command is used to restore the default RIP costing settings for the interface.

The syntax of the default ip rip cost command is:

default ip rip cost [[out-policy <policy_name>] [poison enable] [proxy-announce enable] [receive <rip_version>] [send <rip_version>] [supply enable] [timeout] [triggered enable]]

The default ip rip cost command is executed in the Interface Configuration mode.

default ip rip default-listen command

The default ip rip default-listen command is used to restore the default RIP route listening setting for the interface (disabled).

The syntax of the default ip rip default-listen command is:

default ip rip default-listen enable

The default ip rip default-listen command is executed in the Interface Configuration mode.

default ip rip default-supply command

The default ip rip default-supplycommand is used to restore the default RIP route advertisement setting for the interface (disabled).

The syntax of the default ip rip default-supply command is:

default ip rip default-supply enable

The default ip rip default-supply command is executed in the Interface Configuration mode.

default ip rip enable command

The default ip rip enable command is used to globally disable RIP on the interface.

The syntax of the default ip rip enable command is:

default ip rip enable

The default ip rip enable command is executed in the Interface Configuration mode.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 79
Image 79
Nortel Networks NN47200-503 manual Default ip rip cost command, Default ip rip default-listen command