Nortel Networks NN47200-503 manual Ip ospf dead-interval command, Ip ospf hello-interval command

IP routing configuration using the CLI 97

The ip ospf cost command is executed in the Interface Configuration mode.

ip ospf dead-interval command

The ip ospf dead-intervalcommand is used to configure a dead interval for the interface. This is the interval of time that a Hello packet has not been transmitted from this interface before its neighbors declare it down.

The syntax of the ip ospf dead-intervalcommand is:

ip ospf dead-interval <interval>

The <interval> parameter represents the amount of time in seconds to set this interval at. This is an integer value between 0 and 2147483647.

The ip ospf dead-intervalcommand is executed in the Interface Configuration mode.

ip ospf hello-interval command

The ip ospf hello-intervalcommand is used to configure the amount of time between transmission of hello packets from this interface.

The syntax of the ip ospf hello-intervalcommand is:

ip ospf hello-interval <interval>

The <interval> parameter is the amount of time in seconds between hello packets. This is an integer value between 1 and 65535.

The ip ospf hello-intervalcommand is executed in the Interface Configuration mode.

ip ospf mtu-ignore command

The ip ospf mtu-ignorecommand is used to instruct the interface to ignore the packet MTU size specified in Database Descriptors.

The syntax of the ip ospf mtu-ignorecommand is:

ip ospf mtu-ignore enable

The ip ospf mtu-ignorecommand is executed in the Interface Configuration mode.

ip ospf network command

The ip ospf network command is used to define the type of OSPF interface this interface is.

The syntax of the ip ospf network command is:

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks