Nortel Networks NN47200-503 manual Trap command, No trap command, Area virtual-link command

92IP Routing Configuration and Management

The syntax of the no router-idcommand is:

no router-id

The no router-idcommand is executed in the Router Configuration mode.

timers basic holddown command

The timers basic holddown command is used to configure the OSPF holddown timer.

The syntax of the timers basic holddown command is:

timers basic holddown <timer_value>

The <timer_value> parameter represents a second value between 3 and 60 seconds.

The command is executed in the Router Configuration mode.

trap command

The trap command is used to enable OSPF system traps.

The syntax of the trap command is:

trap enable

The trap command is executed in the Router Configuration mode.

no trap command

The no trap command is used to disable OSPF system traps.

The syntax of the no trap command is:

no trap enable

The no trap command is executed in the Router Configuration mode.

area virtual-link command

Use the area virtual-linkcommand to create a virtual interface. The syntax for the area virtual-linkcommand is:

area virtual-link <A.B.C.D.> <W.X.Y.Z> {[authentication-key <WORD>] [authentication-type {nonesimplemessage-digest}] [primary-md5-key <1-255>] [dead-interval <0-2147483647>] [hello-interval <1-65535>] [retransmit-interval <0-3600>] [transit-delay <0-3600>]

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks