IP routing configuration using the CLI 105

ping-virtual-address enable

The ping-virtual-address enable command is executed in the Router Configuration mode.

no ping-virtual-address enable command

The no ping-virtual-address enable command is used to disable ICMP echo replies from VRRP associated addresses.

The syntax of the no ping-virtual-address enable command is:

no ping-virtual-address enable

The no ping-virtual-address enable command is executed in the Router Configuration mode.

send-trap enable command

The send-trap enable command is used to enable the sending of SNMP notifications after virtual router state changes.

The syntax of the send-trap enable command is:

send-trap enable

The send-trap enable command is executed in the Router Configuration mode.

no send-trap enable command

The no send-trap enable command is used to disable the sending of SNMP notifications after virtual router state changes.

The syntax of the no send-trap enable command is:

no send-trap enable

The no send-trap enable command is executed in the Router Configuration mode.

ip vrrp address command

The ip vrrp address command is used to associated an IP address with a virtual router ID.

The syntax of the ip vrrp address command is:

ip vrrp address <vr_id> <ip_address>

The <vr_id> parameter represents the virtual router being configured. This is a value between 1 and 255. The <ip_address> parameter represents the address to be used in the association.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 105
Image 105
Nortel Networks NN47200-503 No ping-virtual-address enable command, Send-trap enable command, No send-trap enable command