IP routing configuration using the Java Device Manager 271

MatchNetwork

If configured, the switch matches the

 

destination network against the contents of

 

the specified prefix list.

 

 

MatchIpRouteSource

If configured, matches the next hop IP

 

address for RIP routes and advertising router

 

IDs for OSPF routes against the contents of

 

the specified prefix list. This option is ignored

 

for all other route types.

 

 

MatchNextHop

If configured, matches the next hop IP

 

address of the route against the contents of

 

the specified prefix list. This field applies only

 

to non-local routes.

 

 

MatchInterface

If configured, the switch matches the IP

 

address of the interface by which the RIP

 

route was learned against the contents of the

 

specified prefix list. This field is used only

 

for RIP routes and ignored for all other type

 

of route.

 

 

MatchRouteType

Sets a specific route-type to be matched

 

(applies only to OSPF routes). Externaltype1,

 

and Externaltype2 specify the OSPF routes

 

of the specified type only. OSPF internal

 

refers to intra- and inter-area routes.

 

 

MatchMetric

If configured, the switch matches the metric of

 

the incoming advertisement or existing route

 

against the specified value (1 to 655535). If

 

0, then this field is ignored. The default is 0.

 

 

NssaPbit

Set or reset the P bit in specified type 7

 

LSA. By default the P bit is always set in

 

case the user set it to a disable state for a

 

particular route policy than all type 7. LSAs

 

associated with that route policy will have the

 

P bit cleared with this intact NSSA ABR will

 

not perform translation of these LSAs to type

 

5. Default is enabled.

 

 

SetRoutePreference

Setting the preference greater than zero,

 

specifies the route preference value to be

 

assigned to the routes which matches this

 

policy. This applies to Accept policies only.

 

You can set a value from 0 to 255. The default

 

value is 0. If the default is configured, the

 

global preference value is used.

 

 

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 271
Image 271
Nortel Networks NN47200-503 manual IP routing configuration using the Java Device Manager