Nortel Networks NN47200-503 manual Address Resolution Protocol ARP commands, Show arp command

64IP Routing Configuration and Management

Parameter	Description
<O.P.Q.R>	Enter the IP address of the next hop of the route
	being modified.
<1 - 65535>	Enter the new weight, or cost, of the static route.

The ip route weight command is executed in the Global Configuration command mode.

Address Resolution Protocol (ARP) commands

Use the CLI to display, create, configure, and remove ARP entries.

show arp command

The show arp-tablecommand displays ARP entries.

The syntax for the show arp-tablecommand is:

show arp-table [<A.B.C.D>]

Substitute <A.B.C.D> above with the IP address of the ARP table to be displayed.

The show arp-tablecommand is executed in the Global Configuration command mode.

show ip arp command

The show ip arp command displays the IP addresses of ARP entries. The syntax for the show ip arp command is:

show ip arp [<-s> <A.B.C.D.W.X.Y.Z.>] [<static>]

The following table outlines the parameters for this command.

show ip arp parameters

Parameter	Description
-s	Specify the subnet of the ARP entries to be
	displayed.
<A.B.C.D>	Specify the IP address of the ARP entry to be
	displayed. This option is invalid if the switch is not in
	Layer 3 mode.
<W.X.Y.Z>	Enter subnet mask address in dotted decimal
	notation.
static	Display the software ARP table - all configured static
	entries, including those without a valid route.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks