104IP Routing Configuration and Management

The ip rip out-policycommand is executed in the Interface

Configuration mode.

Virtual Router Redundancy Protocol (VRRP) commands

The Virtual Router Redundancy Protocol (VRRP) is designed to eliminate the single point of failure that can occur when the single static default gateway router for an end station is lost.

This section describes the CLI commands used to configure VRRP.

router vrrp enable command

The router vrrp enable command is used to globally enable VRRP on a switch.

The syntax of the router vrrp enable command is:

router vrrp enable

The router vrrp enable command is executed in the Global

Configuration mode.

no router vrrp enable command

The no router vrrp enable command is used to globally disable VRRP on a switch.

The syntax of the no router vrrp enable command is:

no router vrrp enable

The no router vrrp enable command is executed in the Global

Configuration mode.

router vrrp command

The router vrrp command is used to place the switch into Router

Configuration mode for the purposes of VRRP configuration.

The syntax of the router vrrp command is:

router vrrp

The router vrrp command is executed in the Global Configuration mode.

ping-virtual-address enable command

The ping-virtual-address enable command is used to enable ICMP echo replies from VRRP associated addresses.

The syntax of the ping-virtual-address enable command is:

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 104
Image 104
Nortel Networks NN47200-503 manual Virtual Router Redundancy Protocol Vrrp commands, Router vrrp enable command