Nortel Networks NN47200-503 Default ip arp-proxy command, Show ip arp-proxy interface command

IP routing configuration using the CLI 67

no ip arp-proxy [enable]

The no ip arp-proxycommand is executed in the Layer 3 IP VLAN Interface Configuration mode.

default ip arp-proxy command

The default ip arp-proxycommand is used to return the switch to the default proxy ARP settings.

The syntax of the default ip arp-proxycommand is:

default ip arp-proxy [enable]

The default ip arp-proxycommand is executed in the Layer 3 IP VLAN Interface Configuration mode.

show ip arp-proxy interface command

The show ip arp-proxy interface command is used to display the status of proxy ARP on an interface.

The syntax of the show ip arp-proxy interface command is:

show ip arp-proxy interface [vlan <vlan_id>]

The show ip arp-proxy interface command is executed in the User EXEC mode.

Routing Information Protocol (RIP) commands

This section describes the CLI commands used to configure and manage the Routing Information Protocol (RIP) on the Nortel Ethernet Routing Switch 5500 Series. RIP is a distance vector protocol used to dynamically discover network routes based on information passed between routers in the network. RIP is useful in network environments where using static route administration would be difficult.

router rip enable command

The router rip enable command is used to globally enable RIP on the switch. RIP must be globally enabled on the switch before it becomes operational.

The syntax of the router rip enable command is:

router rip enable

The router rip enable command is executed in the Global Configuration command mode.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks