Weed Eater 2600 manual Command, Purpose, pattern01 through pattern12 name pre-set

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

	Command	Purpose
Step 4
	Router(config-voiceport)# ring frequency {25 50}	(FXS only) Selects the ring frequency, in hertz
		(HZ), used on the FXS interface. This number must
		match the connected telephony equipment and may
		be country-dependent. If not set properly, the
		attached telephony device may not ring or it may
		buzz.
		The keyword default is 25 on Cisco 2600 series,
		Cisco 3640 and Cisco 3660 routers.
Step 5
	Router(config-voiceport)# ring number number	(FXO only) Specifies the maximum number of
		rings to be detected before an incoming call is
		answered by the router.
		The default is 1.
Step 6
	Router(config-voiceport)# ring cadence {[pattern01	(FXS only) Specifies an existing pattern for ring, or
	pattern02 pattern03 pattern04 pattern05	defines a new one. Each pattern specifies a
	pattern06 pattern07 pattern08 pattern09	ring-pulse time and a ring-interval time. The
	pattern10 pattern11 pattern12] [define pulse
		keywords and arguments are as follows:
	interval]}
		• pattern01 through pattern12 name pre-set
		ring cadence patterns. Enter ring cadence ? to
		see ring pattern explanations.
		• define pulse interval specifies a user-defined
		pattern: pulse is a number (one or two digits,
		from 1 to 50) specifying ring pulse (on) time in
		hundreds of milliseconds, and interval is a
		number (one or two digits from 1 to 50)
		specifying ring interval (off) time in hundreds
		of milliseconds.
		The default is the pattern specified by the cptone
		locale that has been configured.
Step 7
	Router(config-voiceport)# description string	Attaches a text string to the configuration that
		describes the connection for this voice port. This
		description appears in various displays and is
		useful for tracking the purpose or use of the voice
		port. The string argument is a character string from
		1 to 255 characters in length.
		The default is that there is no text string (describing
		the voice port) attached to the configuration.
Step 8
	Router(config-voiceport)# no shutdown	Activates the voice port. If a voice port is not being
		used, shut the voice port down with the shutdown
		command.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

12