Weed Eater 2600 manual Command, Purpose, Optional Specifies a tone cadence pattern to be

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

	Command	Purpose
Step 10
	Router(config-voice-class)# cadence-listcadence-id	(Optional) Specifies a tone cadence pattern to be
	cycle-1-on-time cycle-1-off-time cycle-2-on-time	detected. Specify an on time and off time for each
	cycle-2-off-time cycle-3-on-time cycle-3-off-time	cycle of the cadence pattern.
	cycle-4-on-time cycle-4-off-time
		The arguments are as follows:
		• cadence-id—Ranges from 1 to 10. There is no
			default.
		•	cycle-N-on-time and cycle-N-off-time—Range
			from 0 to 1000 (0 ms to 10 sec). The default is
			0.
Step 11
	Router(config-voice-class)# cadence-variationtime	(Optional) Specifies the maximum time that the
		tone onset can vary from the specified onset time
		and still be detected, in 10-millisecond increments.
		The time argument ranges from 0 to 200 (0 ms to 2
		sec). The default is 0.
Step 12
	Router(config-voice-class)# exit	Exits voice class configuration mode.
Step 13
	Router(config)# voice-portslot/subunit/port	Enters voice-port configuration mode.
		The arguments are as follows:
		• slot—Specifies the slot number where the
			voice network module is installed.
		•	subunit—Specifies the
			Cisco High-Density Analog Voice/Fax Netwo
			rk Module (NM-HDA) where the voice port is
			located.
		• port—Identifies the analog voice-port number.
			See Table 1 on page 2 for valid entries.
Step 14
	Router(config-voiceport)# supervisory disconnect	Assigns an FXO supervisory disconnect tone voice
	dualtone {mid-call pre-connect}voice-class tag	class to the voice port.
		The keywords are as follows:
		• mid-call—Specifies tone detection during the
			entire call.
		• pre-connect—Specifies tone detection only
			during call setup.
Step 15
	Router(config-voiceport)# supervisory disconnect	Configures the voice port to disconnect on receipt
	anytone	of any tone.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

17