Cisco High-Density Analog Voice and Fax Network Module

debug dspapi

debug dspapi

To enable debugging for Digital Signal Processor (DSP) Application Programming Interface (API) message events, use the debug dspapi command in EXEC mode. To reset the default value for this feature, use the no form of this command.

debug dspapi { all command detail error notification response }

[no] debug dspapi { all command detail error notification response }

Syntax Description

all

Enables all dspapi debug options (command, detail, error, notification and

 

 

response).

 

 

 

 

command

Displays commands sent to the DSPs.

 

 

 

 

detail

Displays additional detail for the dspapi debugs enabled.

 

 

 

 

error

Displays any dspapi errors.

 

 

 

 

notification

Displays notification messages sent from the DSP. (for example, tone

 

 

detection notification).

 

 

 

 

response

Displays responses sent by the DSP (for example, responses to statistic

 

 

requests).

 

 

 

Defaults

Command Modes

Command History

This command is not enabled.

EXEC

Release

Modification

12.1(5)XM

This command was first introduced on the Cisco AS5300 and Cisco AS5800.

 

 

12.1(5)XM1

This command was implemented on the Cisco AS 5350 and Cisco AS5400.

 

 

12.2(2)T

This command was implemented on the Cisco 1700, Cisco 2600 series,

 

Cisco 3600 series, and the Cisco 3810.

 

 

12.2(8)T

This command was integrated into the Cisco IOS Release 12.2(8)T.

 

 

Usage Guidelines DSP API message events used to communicate with DSPs are intended for use with Connexant (Nextport) and Texas Instrument (54x) DSPs. This command severely impacts performance and should be used only for single-call debug capture.

Examples

The following example shows how to enable debugging for all DSP API message events:

 

Router #debug dspapi all

Cisco IOS Release 12.2(2)XT and 12.2(8)T

32

Page 32
Image 32
Weed Eater 2600 Debug dspapi, Syntax Description, Defaults Command Modes Command History, Release Modification, Examples