Weed Eater 2600 debug hpi, Defaults, Command Modes Command History, Usage Guidelines Examples

Cisco High-Density Analog Voice and Fax Network Module

debug hpi

debug hpi

To enable debugging for Host Port Interface (HPI) message events, use the debug hpi command in EXEC mode. To reset the default value for this feature, use the no form of this command.

debug hpi { all command detail error notification response }

[no] debug hpi { all command detail error notification response }

Syntax Description	all	Enables all HPI debug options (command, detail, error, notification and
		response).
	command	Displays commands being sent to the 54x DSP.
	detail	Displays additional detail for the HPI debugs enabled.
	error	Displays any HPI errors.
	notification	Displays notification messages sent from the 54x DSP. (for example, tone
		detection notification).
	response	Displays responses (to commands) sent by the 54x DSP (for example,
		responses to statistic requests).
Defaults	This command is not enabled.

Command Modes

Command History

EXEC

Release	Modification
12.1(5)XM	This command was first introduced on the Cisco AS5300 and Cisco AS5800.
12.2(2)T	This command was implemented on the Cisco 1700, Cisco 2600 series,
	Cisco 3600 series, and the Cisco 3810.
12.2(8)T	This command was integrated into the Cisco IOS Release 12.2(8)T.

Usage Guidelines

Examples

This command enables debugging for HPI message events, which are used to communicate with the 54x DSPs. This command severely impacts performance and should be used only for single-call debug capture.

The following example shows how to enable debugging for all HPI message events:

Router #debug hpi all

Related Commands	Command	Description
	debug dspapi	Enables debugging for DSP API message events.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

34