Weed Eater 2600 manual Tone Injection Tests, Relay-Related Function Tests

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

Tone Injection Tests

To inject a test tone into a voice port, use the following commands in privileged EXEC mode:

	Command	Purpose
Step 1
	Router# test voice port slot/subunit/port inject-tone	Identifies the voice port you want to test and enters
	{local network} {1000hz 2000hz 200hz 3000hz	keywords for the direction to send the test tone and
	300hz 3200hz 3400hz 500hz quiet}	for the frequency of the test tone.
		Note A call must be established on the voice
		port under test.
Step 2
	Router# test voice port slot/subunit/port inject-tone	Identifies the voice port on which you want to end
	disable	the test and enters the keyword disable to end the
		test tone.
		Note The disable keyword is available only if a
		test condition is already activated.

Relay-Related Function Tests

To test relay-related functions on a voice port, use the following commands in privileged EXEC mode:

	Command	Purpose
Step 1
	Router# test voice port slot/subunit/port relay	Identifies the voice port you want to test. Enter a
	{e-lead loop ring-ground battery-reversal	keyword for the relay under test and specify
	power-denial ring tip-ground} {on off}	whether to force it to the on or off state.
		Note For each signaling type (FXO, FXS), only
		the applicable keywords are displayed.
		The disable keyword is displayed only
		when a relay is in the forced state.
Step 2
	Router# test voice port slot/subunit/port relay	Identifies the voice port on which you want to end
	{e-lead loop ring-ground battery-reversal	the test. Enter a keyword for the relay under test,
	power-denial ring tip-ground}disable	and the keyword disable to end the forced state.
		Note For each signaling type (FXO, FXS), only
		the applicable keywords are displayed.
		The disable keyword is displayed only
		when a relay is in the forced state.

Cisco IOS Release 12.2(2)XT and 12.2(8)T

27