Nortel Networks NN47200-503 manual Configuring RIP version

128IP Routing Configuration and Management

interface vlan 3

no ip rip listen enable no ip rip supply enable ! *** Brouter Port *** ! interface fastEthernet ALL

brouter port 2/7 vlan 3 subnet 10.1.1.1/30

The following commands can be used to confirm the configuration of RIP parameters:

Command	Description
show vlan	This command is used to display information about the
	currently configured switch VLANs.
show vlan ip	This command is used to display IP address information
	about VLANs that have been assigned addresses on the
	switch.
show ip rip	This command displays information on the global switch RIP
	configuration.
show ip route	This command displays the switch routing table.
show ip rip	This command displays information about the RIP interfaces
interface	present on the switch.

Configuring RIP version 2

When RIP is enabled on an interface, it operates by default in rip1compatible send mode and rip1orRip2 receive mode. Depending on configuration requirements, the Nortel Ethernet Routing Switch 5500 Series can be configured to operate using RIP version 1 or 2. The configuration illustrated below demonstrates a Nortel Ethernet Routing Switch 5500 Series switch that has been configured to operate use RIP version 2 only.

Note: This example builds on the previous RIP configuration.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks