4.0Care and Maintenance
4.1Cleaning Recommendations
4.1.1Clean all exterior surfaces using a mild
4.2Lamp replacement
4.2.1Replacing the lamp(s) requires (1) end panel removal.
4.2.1.1Unplug the AC line cord from the wall receptacle.
4.2.1.2Remove the filter glass by unscrewing the (2) screws located on either side of the unit.
4.2.1.3Carefully slide the filter glass out of the silver housing. Be careful not to scratch the glass filter or place it on a surface that could cause it to fracture or crack.
4.2.1.4The lamps need to be rotated in the socket to remove and replace. To remove rotate lamp until the lamps pin entry slot on the lamp socket is vertical. Then lift upward to remove.
4.2.1.5When installing the lamps reverse the steps noted above.
4.2.1.6Turn ON the AC Main switch.
4.2.1.7Check to see if all of the lamps have lit.
5.0Service
5.1Trouble shooting
5.1.1Problem: Unit does not operate.
5.1.1.1Ensure device is plugged in and has power.
5.1.1.2Ensure that the lamp(s) are properly seated, both pins on each side of the lamp should make contact with the metal contact in each connector.
5.1.1.3Replace the lamp. The lamp may have an open filament (there is one in each end) or the vacuum may be gone in the lamps glass envelope.
5.1.1.4Contact customer Service for replacement parts.
5.2Customer Service
5.3.1Contact Information
1480 N. Claremont Blvd. Claremont, Ca 91711
Phone | |
Toll free in USA | |
Fax |
info@ultralum.com | |
Web Site | www.ultralum.com |
For software technical support, contact the software manufacturer.
8
