Nortel Networks NN47200-503 manual Auto-vlink command, No auto-vlink command

IP routing configuration using the CLI 95

no area virtual-link message-digest-key <A.B.C.D.> <W.X.Y.Z> <1-255>

no area virtual-link message-digest-key command parameters

Parameter	Description
<A.B.C.D.>	Specifies the transit area ID expressed as an IP address.
<W.X.Y.Z>	Specifies the neighbor router ID expressed as an IP
	address.
<1-255>	Specifies the primary MD5 key value, expressed as an
	integer from 1-255.

The no area virtual-link message-digest-key command is executed in the Router Configuration mode.

auto-vlink command

Use the auto-vlink command to enable global automatic Virtual Link creation. For more information about Virtual Link, see "OSPF virtual link" (page 31)

The syntax for the auto-vlinkcommand is:

auto-vlink

The auto-vlinkcommand is executed in the Router Configuration mode.

no auto-vlink command

Use the no auto-vlinkcommand to disable global automatic Virtual Link creation.

The syntax for the no auto-vlinkcommand is:

no auto-vlink

The no auto-vlinkcommand is executed in the Router Configuration mode.

ip ospf advertise-when-down command

The ip ospf advertise-when-downcommand is used to enable advertisement of the OSPF interface even when the interface is operationally unavailable.

The syntax of the ip ospf advertise-when-downcommand is:

ip ospf advertise-when-down enable

The ip ospf advertise-when-down command is executed in the Interface Configuration mode.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks