66IP Routing Configuration and Management

no ip arp command

The no ip arp command removes an ARP entry.

The syntax for the no ip arp command is:

no ip arp <A.B.C.D>

Substitute <A.B.C.D> above with the IP address of the static ARP entry to remove.

The no ip arp command is executed in the Global Configuration command mode.

ip arp timeout command

The ip arp timeout command configures an aging time for the ARP entries.

The syntax for the ip arp timeout command is:

ip arp timeout <5-360>

Substitute <5-360>above with the amount of time in minutes before an ARP entry ages out. The default value is 360 minutes.

The ip arp timeout command is executed in the Global Configuration command mode.

Proxy ARP commands

This section outlines the commands used to configure and manage Proxy ARP on the Nortel Ethernet Routing Switch 5500 Series.

ip arp-proxy command

The ip arp-proxycommand is used to enable proxy ARP functionality on the switch

The syntax of the ip arp-proxycommand is:

ip arp-proxy enable

The ip arp-proxycommand is executed in the Layer 3 IP VLAN Interface Configuration mode.

no ip arp-proxy command

The no ip arp-proxycommand is used to disable proxy ARP functionality on the switch.

The syntax of the no ip arp-proxycommand is:

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 66
Image 66
Nortel Networks NN47200-503 manual No ip arp command, Ip arp timeout command, Proxy ARP commands, Ip arp-proxy command