Nortel Networks NN47200-503 manual Ip dhcp-relay broadcast command

IP routing configuration using the CLI 119

The show vlan dhcp-relaycommand is executed in the User EXEC command mode.

ip dhcp-relay command

The ip dhcp-relaycommand allows configures DHCP relay settings on a VLAN.

The syntax for the ip dhcp-relaycommand is:

ip dhcp-relay [min-sec <0-65535>] [mode {bootp dhcp bootp_dhcp}]

The following table outlines the parameters for this command.

ip dhcp-relay parameters

Parameter	Description
min-sec <0-65535>	Enter the minimum number of seconds to wait
	between receiving the DHCP packet and forwarding
	it to the destination device. The default is 0.
mode {bootp dhcp	Enter the type of DHCP packets this VLAN supports:
bootp_dhcp}
	• bootp - Supports BootP only
	• dhcp - Supports DHCP only
	• bootp_dhcp - Supports both BootP and DHCP

The ip dhcp-relaycommand is executed in the Interface Configuration command mode.

no ip dhcp-relay command

The no ip dhcp-relaycommand disables DHCP relay on a VLAN. The syntax for the no ip dhcp-relaycommand is:

no ip dhcp-relay

The no ip dhcp-relaycommand is executed in the Interface Configuration command mode.

ip dhcp-relay broadcast command

The ip dhcp-relay broadcast command enables DHCP relay broadcast on a VLAN.

The syntax for the ip dhcp-relay broadcast command is:

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks