Nortel Networks NN47200-503 manual As-boundary-router command, No as-boundary-router command

	IP routing configuration using the CLI 87
no area parameters
Parameter	Description
ip_address	Specifies the Area ID expressed as IP address (A.B.C.D).
import-summaries	Controls the import of summary link state advertisements
{enable}	into stub areas. This setting has no effect on other areas.
range {subnet_mask}	Used to specify range parameters for the OSPF area.
{nssa-entlink
summary-link}

The no area command is executed in the Router Configuration mode.

Note: The configuration of a totally stubby area (no summary advertising) is a two step process. First, define an area with the import flag set to noexternal. Second, disable import summaries in the same area with the command no area <ip_address> import-summaries enable.

as-boundary-router command

The as-boundary-routercommand is used to denote a router as an Autonomous System Boundary Router.

The syntax of the as-boundary-routercommand is:

as-boundary-router {enable}

The as-boundary-routercommand is executed in the Router Configuration mode.

no as-boundary-router command

The no as-boundary-routercommand is used to withdraw a router as an Autonomous System Boundary Router.

The syntax of the no as-boundary-routercommand is:

no as-boundary-router {enable}

The no as-boundary-routercommand is executed in the Router Configuration mode.

default-cost ethernet command

The default-cost ethernet command is used to define the default cost metric of an ethernet (10 Mbps) port.

The syntax of the default-cost ethernet command is:

default-cost ethernet <metric_value>

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks