22An Introduction to IP Routing Protocols

Proxy Address Resolution Protocol (Proxy ARP)

Proxy ARP allows a network station to respond to an ARP request from a locally attached host or end station for a remote destination. It does so by sending an ARP response back to the local host with its own MAC address of the network station interface for the subnet on which the ARP request was received. The reply is generated only if the switch has an active route to the destination network.

The figure below is an example of proxy ARP operation. In this example, host C with a 24-bit mask appears to be locally attached to host B with a

16-bit mask, so host B sends an ARP request for host C. However, the 5500 Series switch is between the two hosts. To enable communication between the two hosts, the 5500 Series switch would respond to the ARP request with host C’s IP address but with its own MAC address.

Proxy ARP Operation

Static routes

Once routable VLANs are created though IP address assignment, static routes can be created. Static routes allow for the manual creation of specific routes to a destination IP address. Static routes can also be used to specify a route to all networks for which there are no explicit routes in the Forwarding Information Base or the routing table. This static default route is a route to the network address 0.0.0.0 as defined by the IEEE RFC 1812 standard.

Because of their static nature, this type of solution is not scalable. Thus, in a large or growing network this type of route management may not be desirable. Also, static routes do not have the capacity to determine the failure of paths. Thus, a router can still attempt to use a path after it has failed.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 22
Image 22
Nortel Networks NN47200-503 manual Proxy Address Resolution Protocol Proxy ARP, Static routes, Proxy ARP Operation