IP routing configuration using the CLI 55

This command tells the router to use up to two paths to get to any

OSPF network destination.

4The configuration can be verified using the following command.

5530-24TFD(config)# show ecmp

—End—

IP routing configuration using the CLI

This section describes the various Command Line Interface commands available for the configuration and management of IP routing. Depending on the type of command and the context in which it is being used, these commands are executed in the various CLI command modes.

IP configuration commands

This section describes the commands for the global IP configuration at the switch level.

ip routing command

The ip routing command enables global routing at the switch level.

The syntax for the ip routing command is:

ip routing

The ip routing command is executed in the Global Configuration command mode.

no ip routing command

The no ip routing command disables IP routing.

The syntax for the no ip routing command is:

no ip routing

The no ip routing command is executed in the Global Configuration command mode.

ip blocking-mode command

Use this command to set the level of IP blocking to perform in the stack. The syntax for this command is:

ip blocking-mode {full none}

The following table outlines the parameters for this command.

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 55
Image 55
Nortel Networks NN47200-503 IP configuration commands, Ip routing command, No ip routing command, Ip blocking-mode command