134IP Routing Configuration and Management

5530-24TFD(config)# route-map rip_pol_2 1 match network Prefix_2

3Add the Route Policy created in step 2 to both RIP core ports.

5530-24TFD(config)# interface FastEthernet 2/1

5530-24TFD(config-if)# brouter vlan 2091 subnet 10.1.1.14/30

5530-24TFD(config-if)# ip rip enable

5530-24TFD(config-if)#ip rip out-policy rip_pol_2 5530-24TFD(config)# interface FastEthernet 2/8 5530-24TFD(config-if)# brouter vlan 2090

subnet 10.1.1.6/30

5530-24TFD(config-if)# ip rip enable

5530-24TFD(config-if)# ip rip out-policy rip_pol_2

—End—

Open Shortest Path First (OSPF) configuration

This section contains examples of common OSPF-related configuration tasks.

The Nortel Ethernet Routing Switch 5500 Series supports the following OSPF standards:

RFC 2328 (OSPF version 2)

RFC 1850 (OSPF Management Information Base)

RFC 2178 (OSPF MD5 cryptographic authentication)

This section provides examples of the common OSPF configuration tasks and includes the CLI commands used to create the configuration.

configuring an IP OSPF interface

An OSPF interface can be configured on a brouter port or on a VLAN. The following section demonstrates the creation of the example OSPF interface illustrated below.

OSPF interface example topology

Nortel Ethernet Routing Switch 5500 Series

Configuration-IP Routing Protocols

NN47200-503 03.01 Standard

5.127 August 2007

Copyright © 2005-2007, Nortel Networks

Page 134
Image 134
Nortel Networks NN47200-503 manual Open Shortest Path First Ospf configuration, Configuring an IP Ospf interface