Allied Telesis AT-8848, AT-8800 Series If installing the switch in a rack Remove the rubber feet

Quick Install Guide 5

5.Place the switch in its operating location

If installing the switch in a rack:

•Remove the rubber feet

•Attach the rack-mounting brackets.

Use the screws provided with the switch to mount it in a rack. Other screws may damage the switch.

• Mount the switch in the rack

6.Apply AC power to the switch

Plug the power cord into the AC power connector on the switch’s rear panel, as shown in Figure 1. The FAULT LED may light for one or two seconds as the switch runs internal tests. If the LED remains lit, refer to the AT-8800 Series Hardware Reference for troubleshooting information.

Figure 1: AT-8848 front panel and rear panel with AC power inlet.

	GBIC
L /A
LINK
ACT
GBIC	49
ENABLED
FAULT
L /A	GBIC
49
50
	50

PORT ACTIVITY L/A LINK 100M ACT LINK 10M ACT D/C FULL DUP HALF DUP COL

L/A	1	D/C	3	5	7	9	11	13	15	L/A	17	D/C	19	21	23	25	27	29	31	L /A	33	D/C	35	37	39	41	43	45	47
	2		4	6	8	10	12	14	16		18		20	22	24	26	28	30	32		34		36	38	40	42	44	46	48

AT-8848

Intelligent Workgroup Switch

ASYN0

RESET

RPS FAULT PWR

7.Fit the power cord retaining clip.

A retaining clip is supplied with the switch for the AC power inlet on the switch’s rear panel. Fit this clip to secure the power cord in place.

8.Check that the Power LED on the switch’s front panel lights green

If the PWR LED fails to light, refer to the AT-8800 Series Hardware Reference for troubleshooting information.

9.Connect the Redundant Power Supply (Optional)

AT-8800 Series switches have a Redundant Power Supply (RPS) connector on their rear panel.

The Switch is designed to operate with the AT-RPS8000 RPS, which can be purchased separately. See the AT-8800 Series Hardware Reference or contact your authorised Allied Telesis distributer or reseller for more information.

10.Install GBICs (Optional)

Slide the GBICs into the GBIC slots. Press each GBIC firmly into place.

A range of GBICs have been tested and approved for use with AT-8800 Series switches. See the AT-8800 Series Hardware Reference or contact your authorised Allied Telesis distributor or reseller for more information, or visit www.alliedtelesis.com/support/ software.

C613-04043-01 REV D