AT-9000/28 Gigabit Ethernet ecoSwitch Installation Guide
31
Installing the Switch in a RackPerform the following procedure to install the switch in a standard 19-inch
rack:
Note
Steps 1, 2, and 3 are optional. They remove the snap-on plastic feet
from the bottom of a switch. The feet can be left on.
1. Place the unit upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from the
bottom of the switch, as shown in Figure 8.
Figure 8. Removing the Feet
3. Turn the switch over.
4. Attach a rack-mount bracket to one side of the switch using four of the
screws that come with the switch, as shown in
.
Figure 9. Attaching Rack-Mount Brackets
AT-9000/28
Gigabit Ethernet Switch with 4 Combo SFP Ports
25
26
27
28
25R
26R
27R
28R
PWR
SYS
MODE
SELECT
COL
SPD
DUP
ACT
RS-232
CONSOLE
1462