Chapter 2: Installation

Installing the Switch in an Equipment Rack

To install the switch in a standard 19-inch equipment rack, perform the following procedure:

1.If the rubber feet are attached to the bottom of the switch, remove them using a flat-head screwdriver.

2.Attach the two rack mount brackets to the sides of the switch using the eight bracket screws that are provided. There are four possible positions in which the brackets may be installed.

Figure 6. Attaching the Rack-Mount Brackets to the Switch

3.Mount the switch in a standard 19-inch equipment rack using four equipment rack screws provided.

38

Page 37 Page 39
Page 38
Image 38
Allied Telesis AT-GS900/8PS manual Installing the Switch in an Equipment Rack
Page 37 Page 39
Top Page Image Contents