8.Plug the other end of the cable into the connector labeled “RPS INPUT” on the back of an Allied Telesis switch.

RPS INPUT

400

9. Tighten the captive screws.

RPS INPUT

401

10.Press the On/Off switch for that power supply to move it to the On (in) position.

LEDs

The power supply has one LED, labeled Status.

Color

Description

Amber

Indicates a fault. The power supply may be faulty, or the power

 

supply is functioning properly but is not correctly connected to an

 

Allied Telesis switch.

Green

The power supply is connected to an Allied Telesis switch and is

 

functioning normally.

The RPS LED on the front of the Allied Telesis switch should be green. For more information about the RPS LED, refer to the installation guide that is shipped with your Allied Telesis switch.

Specifications

Item

Specification

Dimensions (H x W x D)

41.1 x 109 x 248.7 mm

 

(1.62 x 4.29 x 9.79 in.)

Operating Temperature

0° C to 40° C

Storage Temperature

-20° C to 80° C

Relative Humidity

<85% noncondensing

Supply Voltage

12 V

Electrical, Safety, and Emissions Statements

This product meets the following standards.

U.S. Federal Communications Commission

Radiated Energy

Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to operate this equipment.

ON OFF

A2

RPS

OUTPUT

 

 

A2

 

12VDC

AC

 

 

 

 

INPUT

A2/A1

100

-

240

 

 

VAC ~

 

 

 

RPS

OUTPUT

 

 

A1

 

12VDC

A1

ON

 

OFF

402

 

Industry Canada

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

RFI Emissions EN 55022 Class A, EN61000-3-2, EN61000-3-3, VCCI Class A

RFI Emissions

EN 55022 Class A

IImmunity

EN 55024

Note

An AT-PWR3202 Power Supply is NOT hot-swappable into and out of the AT-RPS3204 Redundant Power Supply. To replace an AT-PWR3202 unit, first turn the power off using the appropriate On/Off switch and then remove and replace the power supply.

To remove the connector cable, turn the power off first using the appropriate On/Off switch.

Warning: In a domestic environment this product may cause radio interference in which case the use may be required to take adequate measures.

Electrical Safety UL 60950 (CULUS), EN 60950 (TUV)

Copyright © 2008 Allied Telesis, Inc. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesis, Inc. www.alliedtelesis.com

4

5

6

Page 2
Image 2
Allied Telesis AT-PWR3202 warranty LEDs, Color Description, Specification, Dimensions H x W x D, IImmunity