Allied Telesis SB244-01 manual PCR Module IPG Network affecting No Module Vrrp

Patch SB244-01 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 3

PCR: 02401 Module: IPV6 Network affecting: No

Neighbour discovery and PIM6 caused a fatal error when IPv6 was not enabled, or when the IPv6 feature license was not present. This issue has been resolved.

PCR: 02406 Module: IPV6 Network affecting: No

A Router-Alert option has been added. Also, the SHOW IPV6 MLD

INTERFACE command now works correctly.

PCR: 02407 Module: IPG Network affecting: No

ICMP was sending too many messages back as responses to fragmented packets. This issue has been resolved.

PCR: 02409 Module: IPG Network affecting: No

A warning now appears when the DELETE IP INTERFACE command is executed before the DELETE DVMRP INTERFACE command.

PCR: 02410 Module: VRRP Network affecting: No

VRRP pre-empt mode was not working with advertisement updates of 1 second or more because this did not allow for interface start time on startup. Now a check is made to verify that interfaces are UP before timers are started.

PCR: 02413 Module: IPG, IPX2 Network affecting: No

Static IP ARP entries could not be added to hardware at boot time. Also, an IPX circuit could not be deleted from hardware. These issues have been resolved.

PCR: 02416 Module: DVMRP, IPG Network affecting: No

Multicasting forwarding was not working correctly. This issue has been resolved.

PCR: 02417 Module: VLAN, IPG Network affecting: No

The IGMP port list was not updating correctly when a port went down. This issue has been resolved.

PCR: 02418 Module: IPV6 Network affecting: No

ICMPv6 was returning an error for non-zero fragment offsets. This issue has been resolved.

PCR: 02415 Module: IPG Network affecting: No

Packets with a RIP source address and next hop address that are not on the same subnet as the interface will now be processed. If the received next hop is not on the same subnet, it is treated as 0.0.0.0.

PCR: 02420 Module: SWI Network affecting: No

On GBICs, the link was forced up when the transmit fibre was removed. Once up, the link could not be taken down again by removing the transmit fibre. This issue has been resolved.

Patch SB244-01 for Software Release 2.4.4 C613-10349-00 REV A