Alphasonik PBAT10E owner manual A L L a T I O N

Before starting your installation we recommend to disconnect the battery so there can be no damage done to the electrical system of the vehicle. Before disconnecting the battery make sure that the vehicles source unit does not have a password and if so you have the password in hand to disable the security feature of the source unit. Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off while connecting the terminals. Turn on the various components and slowly advance the volume. Remember to check and recheck all con- nections to insure proper use.

1.Alphasonik recommends using the wires that were supplied with the the kit. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wire come in contact with the vehicle’s chassis.

2.Make sure that your audio system is off while installing and con necting your new Alphasonik enclosure. Failure to do so could result in damaging the speaker beyond repair.

3.Be sure to route the wires to the amplifier where it will be free from sharp objects.

4.To insure long-term reliability, all bare wires and wire-to-wire connections should be soldered and insulated with heat shrink or electrician’s tape. Under no circumstances should you leave any bare wires uncovered, as this can and will lead to the dam age of your speakers.

5.Once you have tested your system and have confirmed that it is operating properly, turn off your system and prepare for the final mounting.

I

N

S T A L L A T I O N

6