Installation
Detachable Front
Panel
Caution
When you install this unit in your car, do not remove the detachable front panel.
If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
•The main unit must be mounted within 35 degrees of the horizontal plane, back to front.
Less than 35°
1 | Mounting Sleeve |
| (Included) |
| Dashboard |
Pressure Plates* This unit
*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.
Remove the Detachable Front Panel (refer to page 6). Remove the mounting sleeve from the main unit (see “Removal” on page 25).
2 | Screw |
| |
| Hex Nut (M5) |
| *2 |
| Bolt Stud |
Metal
Mounting
Strap
*1
This unit
Ground Lead
Chassis
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle’s chassis.
•For the screw marked “*2”, use an appropriate screw for the chosen mounting location.
Connect each input lead coming from an amplifier to the corresponding output lead coming from the left rear of the
