CONTROLS
NEW EL/GL 2000
BALBOA CONTROL
Quick Reference Card
Initial
configuration numbers). This priming mode will last up to four minutes and then begin to preset filter cycles
Temperature Adjustment: 80 F – 104 F (26 C – 40 C)
Once the spa is activated it will begin to heat to 100 F. To change the temperature, press the warm and cool icons on the control. The control will display the current temperature, to see the set temperature press the warm or cool button, after a few seconds the current temperature will return to the display.
Jets/Pumps:
Depending on model, your spa will be equipped with either 2 or 3 pumps. The JET 1 icon controls the main pump. This is a two speed pump. Touch JET 1 once for low speed, twice for high speed and a third time to turn off. Notice that pump one will come on in low speed during filter cycles. Jet 2 is also on a two speed pump, but it will not engage during filter cycles unless you turn it on. If your spa is equipped with a third pump touch JET 3 to engage. This pump runs only in high speed. Touch the JET 3 icon once to turn the pump on and once again to turn it off.
Light:
All spas are equipped with LED lighting systems. The standard lighting system consists of a 9 bulb main light with several different colors. With this system touch the light icon once to turn the light on and once to turn off. The colors are random so you may need to turn the light on and off several times to find your desired color. If you have purchased a spa with the upgraded illuminated spa fountains or perimeter package there are 10 different color settings. Listed below are the different settings:
1.
2.White
3.Aqua (Green and Blue)
4.Purple (Red and Blue)
5.Blue
6.Amber (Red and Blue)
7.Green
8.Red
9.Color Flash. This mode switches colors every few seconds.
10.Strobe. This mode flashes the LEDs on and off like a strobe light.
page 04