Alps Electric Tigra XLS Controls, Preset filter Cycles, Setting the Time, Diagnostic Messages

CONTROLS

Preset filter Cycles:

Your spa is programmed from the factory to filter twice a day for two hours each time. During this time pump one will come on in low speed automatically. The spa is fully operational at this time and safe to use. If for any reason you would like to change the filter settings please refer to the EL/GL Series laminated card.

Setting the Time:

Refer to the EL/GL Series laminated card.

Diagnostic Messages:

If you see a diagnostic message appear on the top side control the spa has indicated a problem. Refer to the EL/GL series card under diagnostic messages. Follow the instructions, if it has a problem you can not fix please contact your dealer for service.

Invert:

Invert is a feature on the Balboa AL9000 or AE9000 control that reverses the LED readout for better viewing from inside the spa. On a two pump system, the invert key is located at the top right of the control. If you have a three pump system, touch the warm button once, and then jet 3 to invert the screen. Repeat, then change the screen back.

**All spas are set-up for twenty minute therapeutic cycles. This means once your spa runs for 20 minutes, it will automatically shut off. Do not be alarmed, your spa is not broken. Hit your Jet icon to activate another 20 minute cycle. This feature is installed for two reasons. One is to remind the owner that they have been in the hot tub for a full therapeutic cycle, and the other is energy conservation.

NOTES

page 05

ALPS-Spas 4400 Steve Reynolds Blvd. Norcross, Georgia 30093

770-381-2022 Fax: 770-925-1900 www.ALPS-spas.com