Altec Lansing PT8051 manual Front Panel Rear Surround Unit, Rear Panel Rear Surround Unit

Front Panel (Rear Surround Unit)

	1	2
1. WIRELESS	Illuminates in a steady state when the main and
	rear surround speakers are synchronized to indicate
	the wireless audio link is operating normally.
	Synchronization between the main and rear units
	will occur automatically when main unit is powered
	on provided the rear surround unit’s power switch
	on the rear panel is in the on position. Flashes when
	the wireless connection between the main and rear
	surround speaker has become unsynchronized. To
	manually resynchronize the main and rear surround
	units press the CONNECT button on the rear panel
	of the main unit.
2. STANDBY	Illuminates when unit is plugged in and the POWER
	ON/OFF switch on the rear panel is in the ON
	position. This light will automatically switch from red
	to green once the main unit has been powered up.

Rear Panel (Rear Surround Unit)

Remote Control

This section describes the function of each control on the remote control used to control the PT8051.

Note:You can also control other components using the remote control once you set the appropriate remote control codes. See the “Programming device remote control codes” section of this manual.

1

2

3

4

9	5
8	6
10
	7

English

1 2

1. Power ON/OFF	Switches power on or off.
2. AC Power Cord	Connect to standard AC outlet. Refer to
	frequency and voltage range for Power Source
	as indicated on rear panel.

1. POWER		Use to toggle between On and Standby modes.
2. VOL +/–		Increases or decreases the overall volume level
		of the unit.
3.	3456	Move to highlight items in the on-screen display
	and OK	(OSD) setup menu. Press OK to confirm.
4. AUDIO		Sets the remote’s shared keys to control the
		PT8051 as opposed to DVD, TV, SAT/CAB or
		AUX devices.
5.	INPUT	Press to cycle through inputs – DVD, TV/SAT,
		AUX, DVD digital, TV/SAT digital and AUX digital.
6.	MUTE	Press to turn off or restore sound.
7.	FRONT, CENTER,	Increases or decreases the volume level of the
	REAR +/– LEVEL	individual channels for the main and rear
		surround units.
8.	BASS	Enhances low frequency or bass output.
9.	MODE	Use to select between DTS, Dolby Digital, Dolby
		Pro Logic II or stereo mode of the system
		depending on the sound modes available from
		your audio source.
10. OSD		Press to enter or exit the on-screen display
		(OSD) setup menu.

5