| DISTRIBUTION AMPLIFIERS | |
APPLICATION DIAGRAM | 5 |
|
| ||
|
|
|
INSTALLING YOUR DISTRIBUTION
AMPLIFIER | 6 |
Step 1. Make sure that the proper power supply is being used with the unit. The use of an incorrect power supply can result in equipment damage not covered by warranty.
Step 2. Connect the power cord to the unit and plug it into the power outlet. The power indicator LED on the front panel will light. This indicates that the unit is operational.
Step 3. Connect the high resolution RGsB or RGBS source to the DA1912SX using coaxial cable with BNC connectors, making sure that the colors match correctly. Then connect one or two monitors or projectors to the output(s) of the DA1912SX. The monitors or projectors must be
Step 4. The Input Termination switch should normally be ON unless the input is being looped to another unit. If the output cables are longer than 100 feet, consider using the Video Level Switch to increase the gain on the outputs of the DA1912SX. The Sync Level switch should normally be in the 4V position.
Step 5. If the image is less than perfect, check all the connections. The unit is very reliable and seldom will be the cause of malfunction. Poor quality cables may often degrade the performance of the product. Make sure that the cables used are coaxial cables and that all pins are in good condition.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.
5
5