SWITCHERS
INSTALLING YOUR SWITCHER | 6 |
Step 1. Make sure that the power input is set to the proper AC voltage in your country. An incorrect setting can result in unit damage not covered by warranty.
Step 2. Connect the power cord to the unit and plug it into the power outlet.
Step 3. Connect the cables from the video sources (computers) to the input channels and connect the output channel to the display device (i.e. monitor or projector)
Step 4. If a control system is used to control the unit connect
Step 5. Verify that the picture quality on the display is good. If you are not receiving a signal, make sure that the display is compatible with the resolution of the computer graphics card.
Contact Closure control requires the use of part # RC5204CC Cable.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
OPERATION | 7 |
7.1 RS-232 CONTROL
The MX2406RM Switcher uses a female
PIN No. | PIN Designation |
1 | No connection |
2 | |
3 | |
4 | No connection |
5 | Ground |
6 | Multiple Switcher Loop |
| Control |
7 | Analog Switch Voltage |
| Input |
8 | +5 V (150 mA max) |
9 | Analog Voltage Output |
9-pin D connector
It is generally recommended to select a single method of control for each application, as the activation of several different controls simultaneously may cause unpredictable results.
The majority of control systems and computers used in presentation system applications use the
To connect the MX2406RM Switcher to a control system or computer for
The following are typical cable wiring pin outs:
IBM PIN No. | MX2406RM PIN No. |
3 | 2 |
2 | 3 |
7 | 5 |
Connection
7