4.1. VIDEO SELECT MODE

SWITCHERS

There are two sections on the front panel of the MX2436RM: input select and switcher control. The buttons within the input select section allow for the actual switching of the source signals. The buttons within the switcher control section allow access to the switcher setup features.

4.1. VIDEO SELECT MODE

Default video and audio inputs connect to video and audio outputs simultaneously, but if needed the user may select video and audio inputs separately using AUDIO BREAK AWAY mode. The user can select any video input by using the input select buttons located on the front panel.

4.2. AUDIO BREAK AWAY MODE

This mode allows independent selection of video and audio inputs. After choosing AUDIO BREAK AWAY mode the user may select any audio input for switching when the power is turned ON.

4.3. EQUALIZATION MODE

With video signals connected from input to output through a video amplifier along with an equalization circuit, the user can equalize video signals for each of the inputs according to the distance (cable length) from the video source (PC) to the switcher.

4.4. AUTO SWITCH MODE

If AUTO SWITCH mode is turned ON, the input which was previously selected by the incoming video signal will automatically connect to the output.

If the user does not previously select the AUDIO BREAK AWAY mode, the same number of audio inputs will be connected to the audio output.

4.5. AUTO ROTATION MODE

The user may select AUTO ROTATION mode with a preset rotation time. If this mode is selected, then all video inputs connected to the video output will be selected alternately. Audio inputs will simultaneously connect to the audio output along with video inputs if the user did not previously select AUDIO BREAK AWAY mode.

4.6 AUDIO VOLUME CONTROL

This feature allows the user to control the audio volume using the UP or DOWN buttons. To

increase the volume, push the UP button and to decrease the volume, push the DOWN button.

4.7. VERTICAL INTERVAL SWITCHING MODE

The VERTICAL INTERVAL SWITCHING mode will be activated automatically if the house sync BNC connector is connected to the house sync source or composite video is connected to Input 1. If House Sync is not connected and the Composite Video signal is present on Input 1, then the vertical interval switching process will be controlled by Vertical Sync from the composite video signal.

4.8. BEEP ON/OFF MODE

If the BEEP ON/OFF mode is selected, each control on the control panel, except the RESET mode will be without an accompanying beeper sound.

4.9. RESET MODE

RESET mode sets the memory for the MX2436RM Switcher. To reset the switcher, press the RESET button. In the reset mode, video input 1 and audio input 1 will be active. Auto Switch mode will be disabled if previously active. Beep On/Off mode will return to the ON position if previously in the OFF position. The Reset mode button does not affect Audio Volume, Video Equalization, Auto Rotate or the Sync Delay mode.

4.10 FACTORY RESET MODE

This mode clears all data from memory, which was previously set by the user and returns the switcher to the factory-preset position. To return the switcher to the Factory Reset mode, turn OFF the power, press the Reset button, turn power ON and then release the Reset button.

5

Page 6
Image 6
Altinex MX2436RM manual Video Select Mode, Audio Break Away Mode, Equalization Mode, Auto Switch Mode, Auto Rotation Mode