Altinex SP107-101/101C manual Precautions / Safety Warnings, General

DESIGNER SOLUTIONS

PRECAUTIONS / SAFETY WARNINGS 1

Please read this manual carefully before using your SP107-101AV Interconnect. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your SP107-101and to prevent fire and shock hazards. Please read them carefully and heed all warnings.

1.1 GENERAL

∙Unauthorized personnel shall not open the unit. There are high-voltage components inside.

∙Qualified ALTINEX service personnel or their authorized representatives must perform all service.

1.2 INSTALLATION PRECAUTIONS

∙For best results, place the SP107-101in a dry area away from dust.

∙To prevent fire or shock, do not expose this unit to water or moisture. Do not place the SP107-101in direct sunlight, near heaters or heat-radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

∙Handle the SP107-101carefully. Dropping or jarring can damage the bezel.

∙Never place fingers inside the opening on either side of the unit. This action could cause injury due to sharp edges inside.

∙Disconnect the SP107-101’s power cord to turn off the main power. This supplies power to the AC sockets on the panel. The power outlet should be installed near the equipment and should be easily accessible.

∙We recommend using wall outlets with a Ground Fault Circuit Interrupter (GFCI) for maximum protection.

∙Install all cables according to the instructions found herein. Do not force or pull any cable or power cord that is attached to the SP107-101.

1.3 CLEANING

∙Surfaces should be cleaned with a dry cloth. Never use strong detergents or solvents such as alcohol or thinner. Do not use a wet cloth or water to clean the unit.

1.4 FCC NOTICE

∙This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

∙This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions found herein, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his expense.

∙Any changes or modifications to the unit not expressly approved by ALTINEX, Inc. could void the user’s authority to operate the equipment.

400-0520-001 2